Zebra HC100 - Setting, Changing, and Restoring Print Server Settings

Advanced User Information
Setting, Changing, and Restoring Print Server Settings
66
61207L-002 B HC100 User Guide 11/15/10
Setting, Changing, and Restoring Print Server Settings
Your printer may include an optional ZebraNet 10/100 Internal Print Server (wired Ethernet)
or a ZebraNet
Internal Wireless Plus Print Server (wireless Ethernet).
For additional information, refer to the manuals for your wired or wireless print server. Copies
of the manuals are available at http://www.zebra.com/manuals or on the user CD that came
with your printer. For instructions on accessing the printer’s web pages, see Web Pages
on page 69.
Connecting for the First Time
ZebraNet 10/100 Internal Print Server To configure the 10/100 Internal Print Server,
connect the printer to your Local Area Network (LAN) using an Ethernet cable. By default, the
printer is set for dynamic IP resolution, so it should acquire an IP address. Print a printer
configuration wristband to find the printer’s IP address (see Viewing Printer Settings
on page 56). If you need to change parameters before you can connect the first time, use the
serial or USB port to send the appropriate ZPL or SGD commands.
Zebranet Internal Wireless Print Server See the ZebraNet Wireless User Guide for
configuration instructions. Before you can connect your printer to your Wireless Local Area
Network (WLAN) or view the printer’s web pages, you need to set the printer’s parameters to
match your WLAN. Use the serial or USB port to send the appropriate instructions to the
printer.
After the printer connects to your WLAN, you can access the printer’s web pages to make
changes to the settings. Print a printer configuration wristband to find the printer’s IP address
(see Viewing Printer Settings on page 56).
Changing Parameters after Connecting
Table 9 shows basic print server parameters and what you can use to modify them. For all
other print server parameters, refer to the manuals for your wired or wireless print server.
Table 10 • Print Server Parameters
Parameter Details
IP ADDRESS View or Change the Printer’s IP Address
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address.
Corresponding ZPL Command: ^ND, ^NS (wired), or ^WI (wireless)
Corresponding SGD Command: internal_wired.ip.addr (wired) or
wlan.ip.addr (wireless)
Located on Web Page: TCP/IP Settings