Zebra HC100 - Page 67

67
Advanced User Information
Setting, Changing, and Restoring Print Server Settings
11/15/10 HC100 User Guide 61207L-002 B
IP PROTOCOL Select the Method to Obtain an IP Address
This parameter tells if the user (permanent) or the server (dynamic) selects the
IP address. If a dynamic option is chosen, this parameter tells the method by
which the print server (wired or wireless) receives the IP address from the server.
Selections: ALL, BOOTP, DHCP, DHCP AND BOOTP, PERMANENT
Default Value: All
Corresponding ZPL Command: ^ND, ^NS (wired), or ^WI (wireless)
Corresponding SGD Command: internal_wired.ip.protocol (wired)
or wlan.ip.protocol (wireless)
Located on Web Page: TCP/IP Settings
SUBNET MASK View or Change the Subnet
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 255.255.255.0
Note • Leading zeroes are not shown in the address.
Corresponding ZPL Command: ^ND, ^NS (wired), or ^WI (wireless)
Corresponding SGD Command: internal_wired.ip.netmask (wired) or
wlan.ip.netmask (wireless)
Located on Web Page: TCP/IP Settings
DEFAULT GATEWAY View or Change the Gateway
This parameter can be modified only when PERMANENT is selected for
IP PROTOCOL.
Selections: 0 to 255 for each field
Default Value: 0.0.0.0
Note • Leading zeroes are not shown in the address.
Corresponding ZPL Command: ^ND, ^NS (wired), or ^WI (wireless)
Corresponding SGD Command: internal_wired.ip.gateway (wired) or
wlan.ip.gateway (wireless)
Located on Web Page: TCP/IP Settings
Table 10 • Print Server Parameters (Continued)
Parameter Details