Zebra KR203 - Page 3

P1066584-001 KR203 KPL Programming Manual Page 3 of 58
3.6.7
Recall parameters - <ESC>&F<N1> ......................................................... 18
3.6.8 Exit application - <ESC><255><n1> ........................................................ 19
3.6.9 Load application - <ESC><0><Application data> ...................................... 19
3.6.10 Calibrate Media - <ESC># ........................................................................ 20
3.6.11 Calibrate System - <ESC>g ...................................................................... 20
4 PARAMETERS ..................................................................................... 22
4.1 Parameters Overview ...................................................................................... 22
4.1.1 6 – Secondary burn time .......................................................................... 23
4.1.2 7 – Primary burn time .............................................................................. 23
4.1.3 8 – Max print speed ................................................................................. 24
4.1.4 9 – Presenter loop length ......................................................................... 24
4.1.5 31 – Presenter speed ............................................................................... 24
4.1.6 34 – Auto cut and present after FF ............................................................ 24
4.1.7 35 – TOF Synchronization ......................................................................... 24
4.1.8 37 – Page length ...................................................................................... 25
4.1.9 39 – TOF marker length ........................................................................... 25
4.1.10 40 – Garbage filter ................................................................................... 25
4.1.11 41 – TOF cut offset .................................................................................. 25
4.1.12 45 – Eject timeout.................................................................................... 26
4.1.13 46 – Cut position calibration ..................................................................... 26
4.1.14 47 – Wall compensation ........................................................................... 26
4.1.15 48 – Print width ....................................................................................... 26
4.1.16 49 – Advance before cut ........................................................................... 26
4.1.17 51 – TOF marker sensitivity ...................................................................... 27
4.1.18 53 – Lock parameters ............................................................................... 27
4.1.19 57 – System ............................................................................................ 27
4.1.20 58 – Out of paper level ............................................................................. 27
4.1.21 65 – Status mode ..................................................................................... 28
4.1.22 66 – Status protocol ................................................................................. 28
4.1.23 67 – Information Level ............................................................................. 28
4.1.24 68 – End of paper threshold ..................................................................... 29
4.1.25 69 – Installed guide width ........................................................................ 29
4.1.26 70 – Presenter PWM percentage ............................................................... 29
4.1.27 71 – EOP PWM percentage ....................................................................... 29
4.1.28 75 – Keepalive timeout ............................................................................. 29
4.1.29 80 – Compensation mode ......................................................................... 30
4.1.30 81 – 84 Compensation ............................................................................. 31
4.1.31 248 – Last reset reason ............................................................................ 31
4.1.32 249 – Power down count .......................................................................... 32
4.1.33 250 – Media length (m) ............................................................................ 32
4.1.34 251 – Number of cuts............................................................................... 32
4.1.35 252 & 253 – Page Erases .......................................................................... 32