106
QLn Series User Guide
Appendix H
Alert Messages
The following alert messages will be displayed to inform the
user of various fault conditions that may occur with the QLn
Series printer.
Line One (Status) Line Two (Action) Notes
MEDIA OUT LOAD MEDIA
MEDIA COVER OPEN CLOSE MEDIA COVER
MAINTENANCE NEEDED CLEAN PRINTHEAD
HEAD MAINTEN. NEEDED PRINTING HALTED
PAPER JAM REMOVE MEDIA
PRINTHEAD OVERTEMP PRINTING HALTED
BATTERY DIMINISHED CONSIDER REPLACING
WARNING - BATTERY IS PAST USEFUL LIFE
REPLACE BATTERY SHUTTING DOWN
BATTERY FAILED REPLACE BATTERY
BATTERY LOW CHARGE BATTERY
CHARGING TEMP FAULT MUST BE 0-40
o
C Battery Over Temp
CHARGING TEMP FAULT MUST BE 0-40
o
C Battery Under Temp
CHARGING FAULT REPLACE BATTERY
DOWNLOADING FIRMWARE
DOWNLOAD FAILED PLEASE REBOOT
FIRMWARE WRITING TO FLASH
LOOKING FOR UPDATES PLEASE WAIT. . . When searching for
updates
RETRIEVING FIRMWARE DO NOT POWER OFF! When retrieving an
application
RETRIEVING NEW FILES PLEASE WAIT. . . When downloading files
SENDING FEEDBACK PLEASE WAIT. . . When sending feedback
MIRRORING COMMANDS N/A
MIRROR PROCESSING FINISHED
LOSS OF SIGNAL MOVE IN RANGE OF AP For 802.11
models only
SIGNAL RESTORED N/A For 802.11
models only
Note • Highlighted rows indicate Mirror Alert Messages. The mirror
function is only available on units with either an 802.11 radio,
Ethernet, or both.
To Next Page
Loading...
