Zebra QLn420 - Page 18

P1057798-001 rev. B • QLn420 Repair Procedures • 2-18 •
Installing the Media Cover
1. The Media Cover Assembly
consistes mainly of the Cover,
Platen Holder, Platen (with
bearings and gears), and Black Bar
Flex Cable (as shown).
2. Align the hinges of the Media
Cover Assembly with the hinges
on the Media Guide Plate (where
shown).
3. Insert the Torsion Spring in the
two holes on the Media Guide
Plate (where shown).
4. Slide the Hinge Pin through the
hinge slots and through the
torsion spring (as shown).