• 2-23 • P1057798-001 rev. B • QLn420 Repair Procedures
5. Place the gear on the longer
end of the Platen with the flange
facing toward the bearing.
6. Using a torque driver (2.5 +/- 1 in.
lb.), secure the gear to the shaft
with a 2-56 x 3/16 TR Hd screw.
7. Install a bearing sleeve over the
opposite end of the Platen shaft.
Secure with a 2-56 x 3/16 TR Hd
screw.
8. Install the Peel Bar into the hole
on one end of the Platen Holder.
Flex the opposite end of the
holder to insert the other end of
the Peel Bar.
9. For linerless, replace the BA16937-
1 Media Disks with BA16695-2
Media Disks by removing a screw
and washer.
To Next Page
Loading...
