P1057798-001 rev. B • QLn420 Repair Procedures • 2-30 •
8. Install the Extension Spring from
the post on the Spring Bar to the post
on the Latch Fork (as shown).
9. Secure the Frame to the Media
Guide Plate with (3) screws in the
locations shown. Be sure to route
the Gap Sensor Flex Cable through
the slot on the back of the Frame
(circled).
10. Route the Head-up Switch Cable
through the hole on the side of the
Frame (yellow arrow) and the Black
Bar Cable in the channel on the
Frame (red arrow). Both cables must
be routed behind the peeler bar as
shown.
11. Install Peeler Assembly over the
pin on the actuator (circled) and
use a torque driver to secure with a
shoulder screw (where indicated).
To Next Page
Loading...
