Zebra TLP 2844-Z User Manual

3. The printer has failed its power on self test (POST).
■
If this error occurs right after you turn on the printer, contact an
authorized reseller for assistance.
There is a shortage of memory.
■
If this error occurs after you have been printing, turn the printer power
off and on. Then, resume printing.
4. The printer is receiving data.
■
As soon as all of the data has been received, the status LED will turn
green; then, the printer will automatically resume operation.
5. Either the media or ribbon is out.
■
Load a roll of media, following the instructions in “Loading the Media”
on page 9. Then, press the feed button to resume printing.
■
Load a roll of ribbon, following the instructions in “Loading the
Ribbon” on page 12. Then, press the feed button to resume printing.
The print head is open.
■
Close the top cover. Then, press the feed button to resume printing.
6. The printer is paused.
■
Press the feed button to resume printing.
38 980410-001 Rev. B

Zebra TLP 2844-Z Specifications

General

Resolution	203 dpi
Media Sensors	Reflective and transmissive
Print Method	Direct Thermal
Print Width	4.09 inches
Max Print Speed	4 inches per second
Max Print Length	39 inches
Connectivity	USB, Serial, Parallel
Media Handling	Roll-fed, Fanfold
Label Roll Capacity	5" (127 mm) O.D.
Supported Barcode Types	Code 39, Code 128, UPC, EAN, Interleaved 2 of 5
Supported Media Types	Roll-fed or fanfold, die-cut labels with or without black mark, tag stock, continuous receipt paper, wristbands
Media Width	1.0" (25.4 mm) to 4.25" (108 mm)
Media Thickness	0.003 inches (0.08 mm) to 0.0075 inches (0.19 mm)
Operating Temperature	40°F (5°C) to 105°F (41°C)
Storage Temperature	-40°F (-40°C) to 140°F (60°C)
Power Requirements	100-240 VAC, 50-60 Hz