Need help?Do you have a question about the Zeiss CONTURA G2 and is the answer not in the manual?
General| Type | Coordinate Measuring Machine (CMM) |
|---|---|
| Software | ZEISS CALYPSO |
| Measuring range Z | 600 mm - 1000 mm (depending on model) |
| Probing | ZEISS VAST family (active scanning), discrete point probing |
| Operating Temperature | 18 °C - 22 °C |
| Air Pressure | 6 bar |
| Power Supply | 50/60 Hz |
Specifies minimum room height for CMM, including overhead clearance.
Details floor surface requirements, emphasizing accessibility and distance from walls.
Covers permissible ambient temperature, humidity, and sound levels for optimal CMM operation.
Ensures the floor surface is clean and within acceptable unevenness limits.
Recommends dedicated power sources, avoiding high-consumption or high-interference equipment.
Lists specifications for line power supply, voltage fluctuations, frequency, and interference peaks.
Advises on line analysis and measures like stub cables for voltage stabilization.
Specifies requirements for compressed air supply, including pressure, quality, and connections.
Provides guidelines for unloading, storing, and unpacking the CMM, emphasizing careful handling.
Advises having a system specialist present when moving the CMM to prevent damage.
Provides dimensions and weights for shipping crates and pallets for different CMM configurations.
Shows installation dimensions for the standard CONTURA G2, including clearances and cable lengths.
Provides installation dimensions for the CONTURA G2 with optional U-profile, including clearances and cable lengths.
Details the setup of a restricted-access zone around the CMM with warning signs.
Illustrates the arrangement of steel plates and shows floor load calculations for different configurations.
Shows the dimensions and fastening hole matrix for the X=700, Y=700 measuring table.
Shows the dimensions and fastening hole matrix for the X=700, Y=1000 measuring table.
Shows the dimensions and fastening hole matrix for the X=1000, Y=1200 measuring table.
Shows the dimensions and fastening hole matrix for the X=1000, Y=1600 measuring table.
Shows the dimensions and fastening hole matrix for the X=1000, Y=2100 measuring table.
Shows table dimensions and fastening holes for X=1000, Y=1200 with U-profile.
Shows table dimensions and fastening holes for X=1000, Y=1600 with U-profile.
Shows table dimensions and fastening holes for X=1000, Y=2100 with U-profile.
Provides cutout patterns for the Contura G2 for various X/Y measuring ranges.
To Next Page
