Zeiss HFA3 - Steps to Connect Display and Peripherals to ZEISS HFA3; HFA3 CPC Model Port Configuration; HFA3 Mini-ITX Model Port Configuration; Video Extension Cable Options

Video Extension Cable Options for HFA3
•
DisplayPort cables – (preferred type) recommend
5 meters, or less, due to monitor specification limit.
•
VGA cables – recommend 5 meters, or less.
Signal quality could be affected.
HFA3 side connection HFA3 side connection
2
Steps to connect display and peripherals to ZEISS HFA3
Connecting an additional monitor and peripherals to HFA3
•
Remove the back panel of the HFA3 and locate an available video port.
Note: Two different computer models have been used with HFA3 that have different port configurations (CPC and Mini ITX).
•
Connect a second monitor to the HFA3 using the available video port(s).
•
Position the second monitor an extended distance away from the HFA3.
HFA3 (CPC model) - serial numbers below 8x0-15000
1
Video Signal: 1024 x 768, 60 Hz, (4:3 Aspect Ratio)
Dual Monitor Mode: Mirror
External displays can be added to the following port(s):
DisplayPort
1
Video Signal: 1024 x 768, 60 Hz, (4:3 Aspect Ratio)
Dual Monitor Mode: Mirror
External displays can be added to the following port(s):
DisplayPort (Use this one)
DisplayPort (Do Not use this one)
VGA (OK to use but not preferred)
1
2
3
12
3
HFA3 (Mini-ITX model) - serial numbers higher than 8x0-15000
Note: Do not use HDMI type connector. Not compatible with HFA3.