Why does my Zeiss VISULAS YAG III say 'Excess temperature, please wait!'?
The internal monitoring systems have detected an excess temperature. Please wait a moment. If this fault occurs frequently, ensure that the instrument’s ventilation slots are not covered and that the ambient temperature falls below 35 °C.
What to do if the Zeiss VISULAS YAG III displays demo in STANDBY and READY modes and the laser cannot be triggered?
Switch the VISULAS YAG III off and then on again. While the progress bar is active during the system test on YAG III, touch the ZEISS logo on the screen, then press the rotary knob/button.
What to do if the Zeiss VISULAS YAG III displays demo beside the info button and the laser cannot be triggered?
Switch the instrument off and then on again. While the progress bar is active during the system test, touch the ZEISS logo on the screen, then press the rotary knob/button.
What to do if my Zeiss Medical Equipment says 'Door interlock is active, please close door.'?
Shut the door or check that the shorting plug is correctly plugged into the yellow socket.
What to do if my Zeiss VISULAS YAG III Medical Equipment says 'Please release actuator!'?
Release foot or hand switch.
What to do if my Zeiss VISULAS YAG III says 'LASER STOP is activated; please unlock.'?
Unlock the LASER STOP button.
What to do if my Zeiss VISULAS YAG III says 'Slit lamp not connected!'?
Check that the slit lamp is properly connected.
What to do if my Zeiss Medical Equipment says 'No foot switch connected!'?
Connect the foot switch or operate the instrument using the hand switch. Select the required triggering mode.
What to do if my Zeiss VISULAS YAG III shows 'Swivel lamp casing out of position'?
Swivel the lamp casing out of position. Check that all the connectors on the rear of both consoles are inserted properly.
Explains the manual's purpose and how to access documentation.
Lists package components and explains the meaning of safety symbols used in the manual.
Outlines essential safety guidelines and warnings for operating the VISULAS YAG III.
Provides country-specific details, declarations, and labels for the VISULAS YAG III device.
Covers intended use, side effects, contraindications, and required user qualifications.
Details essential performance features, operational principles, and technical data of the VISULAS YAG III.
Covers general hazards, electrical safety, and fire risks during installation.
Specific steps for installing the VISULAS YAG III Combi and Trion Combi systems.
Guides on fitting the ACCENTO eyepiece and using the ACCENTO foot switch.
Outlines daily checks, system startup, and function tests for the VISULAS YAG III.
Guides on operating the system, using the menu, and understanding different modes.
Details procedures for maintaining the device, including cleaning, fault remedy, and safety inspections.
Lists common error messages and guides for resolving slit lamp and system faults.
Explains the four-point aiming beam system for precise targeting.
Details the focus shift settings for optimizing mechanical effects.
Lists available accessories and provides comprehensive technical specifications and EMC information.
Provides definitions, lists figures, and offers an index for quick reference.
General| Wavelength | 1064 nm |
|---|---|
| Pulse Duration | 4 ns |
| Cooling | Air-cooled |
| Footswitch Control | Yes |
| Laser Type | Nd:YAG |
| Energy | 0.3 to 10 mJ |
| Energy Output | Up to 10 mJ |
| Repetition Rate | 1, 2, or 3 Hz |
| Aiming Beam | 635 nm red diode laser |
| Electrical Requirements | 100-240 V, 50/60 Hz |
To Next Page