How to improve insufficient contrast/brightness in Zeiss MultiSEM 505?
If you find the contrast/brightness insufficient on your Zeiss Medical Equipment images, try increasing the contrast and/or brightness of the detectors.
What causes arcing events in Zeiss Medical Equipment?
If you experience an arcing event with your Zeiss Medical Equipment, it could be due to a high voltage insulator being contaminated or a failure of stage or objective lens high voltage. Plasma-clean the specimen chamber using default settings of the plasma cleaner (15 min). If the arcing continues, execute Tools > Reset Hardware Controllers > Chamber EHT via the menu bar. Repeat the above steps for up to three times. If not successful, contact your ZEISS service representative.
How to fix inaccurate navigation via an overview image in Zeiss MultiSEM 505 Medical Equipment?
If navigation via an overview image is inaccurate on your Zeiss Medical Equipment, the current Shuttle & Find calibration might be obsolete, for example, if a different specimen holder is used. Repeat the Shuttle & Find calibration.
Why are images digitally distorted on Zeiss Medical Equipment?
If the images on your Zeiss Medical Equipment are digitally distorted, or seem to consist of sub-images, it could be that the image acquisition rack and the scan generator are out of sync. Try stopping the image acquisition. Also, change the scanspeed and image size to their default values, then change the settings to their previous values again, and restart the acquisition.
What to do if the specimen stage does not move on Zeiss MultiSEM 505 Medical Equipment?
If the specimen stage on your Zeiss Medical Equipment does not move, it might not be initialized. Try re-calibrating the specimen stage.
Why does the autofocus routine fail repeatedly on Zeiss MultiSEM 505?
If the autofocus routine fails repeatedly on your Zeiss Medical Equipment, there could be a couple of reasons. First, try focusing manually. If that doesn't work, navigate to the Auto Tuning tool and click Noise Constants in the Autofocus / Auto Stigmation section.
What to do if the scan image is black in Zeiss Medical Equipment?
If the scan image is displayed in black on your Zeiss Medical Equipment, the stage position might be too low. Move the stage to the correct Z position.
Why beam or gun cannot be switched on in Zeiss MultiSEM 505 Medical Equipment?
If the beam or gun on your Zeiss Medical Equipment won't switch on, it might be due to insufficient vacuum. In the System Control tool, click 'Pump' and wait until the vacuum indicator displays in green.
How to adjust a too dark or too bright image in Zeiss Medical Equipment?
If the image displayed in the Center Screen Area is too dark or too bright on your Zeiss Medical Equipment, the histogram settings might be unsuitable. Via the Histogram tab in the Center Screen Area, click Reset.
General| Brand | Zeiss |
|---|---|
| Model | MultiSEM 505 Series |
| Category | Medical Equipment |
| Language | English |
To Next Page