Zelmer CM1001D - Page 109

109
CM1001-001_v01
5
Insert the  lter holder in the appliance.
6
Place the permanent nylon  lter or a paper  lter in the
 lter holder.
7
Close the lid.
8
Make sure that the jug lid is in place. Put the empty jug
on the hotplate.
9
Pull the power cord out of the storage compartment
at the back of the appliance and insert the plug into a wall
socket.
 Thepowercordmaybeadjustedtotherequired
length.
• To increase the length of the cord, take
holdofthecord(donotgrasptheplug)and
gentlypullitdownandthanallthewayout
untilyoufeelresistance.
• Toreduce thecord,pushexcesscord into
thestoragecompartmentatthebackofthe
appliance. After adjusting the length, lock
thecordbypullingitallthewayupintothe
cut-outsectionofthehousing.
10
For the  rst use, operate the coffee maker with water
only, following the brewing instructions described below in
section BREWING COFFEE.
 This process will allow you to remove dust
and debris generated during production and
assemblyofyourappliance.