118 CM1001-001_v01
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
Ecology – environment protection
Each user can protect the natural environment. It is neither
difcult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.
Donotdisposeintothedomesticwastedisposal!!!
PROBLEM POSSIBLE CAUSE SOLUTION
Coffee spills over
the lter holder.
The jug was removed while brewing and not replaced
within 30 seconds.
If the jug is removed when brewing is in progress, make
sure to replace it within 30 seconds (see Sneak-A-Cup®
section).
The jug is not positioned centrally on the hotplate.
Pull out the jug and replace it so that it rests centrally in
the hollow section of the hotplate.
The freshly brewed
coffee contains
coffee grounds.
The permanent or paper lter is not properly inserted.
Place a paper or permanent lter in the lter holder and
insert the holder into the appliance.
It takes very long to
brew coffee. Coffee
does not taste well.
The appliance requires cleaning. Coffee type was not
suitable for use with lter coffee makers.
Follow the cleaning instructions. Only use coffee suitable
for use with lter coffee makers.
No coffee comes out
or it comes out very
slow.
No water in the water tank. Fill the water tank with water.
Paper or permanent lter is not positioned correctly. Check if the lter is positioned correctly.
Coffee is too nely ground and clogs the lter. Use coffee suitable for this type of coffee maker.
Appliance is clogged by mineral deposits. Follow the instructions in the DESCALING section.