Zenair CH2000 - Page 26

TABLE 1 – ZENAIR INSPECTION FORM
Make / Model
ZENAIR CH2000
Serial No.
Airframe Hours
Type of Inspection
(Circle One)
Registration No:
Engine Hours
50 100 500 1000
Symbols: + Indicates perform task, - Indicates do not perform task
Task
Refer to
Intervals
(Flight Hours)
Initials
50
100
500
1000
2. Inspect stabilator trim actuator wheel
for security, wear, damage, etc.
3. Perform operational check of stabilator
trim system.
4. Inspect rudder, stabilator and trim tab
hinges for wear and excessive play.
5. Lubricate the rudder and stabilaor trim
tab hinges, the stabilator hinge points
and the trim actuator.
6. Inspect the stabilator balance weight,
stops and grounding strap for security,
condition, damage, etc.
Section VII
Section VII
Section II
Section VII
-
-
-
+
-
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
3-10 Nov-2