What to do if my ZENEC ZE-DAB60 device does not work?
If the ZENEC Tuner device isn't working, first ensure the power supply wiring harness is properly connected. Also, check the power supply fuse and replace it if it's blown, using a new one with the same ampere rating. Finally, make sure the device is turned on and not in stand-by mode.
Why do all channels have low signal quality in DAB/DAB+ mode on my ZENEC Tuner?
If, in DAB/DAB+ mode, all channels show low signal quality on your ZENEC Tuner, check the antenna connection and try repositioning the antenna. Also, verify that DAB/DAB+ radio service is available in your area, consulting your country's DAB/DAB+ radio coverage map, as digital radio is unavailable in non-covered areas.
What to do if the ZENEC ZE-DAB60 Tuner remote control doesn’t work?
If the optional ZENEC Tuner remote control isn't working, ensure the external IR receiver is connected. Replace the remote's battery with a new one of the same type if it's exhausted. Make sure the remote is pointed at the IR receiver without any obstructions. If none of these steps work, the remote itself might be defective and need replacement.
Why is there no audio during video playback on my ZENEC ZE-DAB60 Tuner?
If you're experiencing video playback but no audio with your ZENEC Tuner, the audio might be muted. Try increasing the volume or deactivating the muting function.
Why is the number of radio channels not as much as expected in DAB/DAB+ mode on my ZENEC ZE-DAB60 Tuner?
If the number of radio channels in DAB/DAB+ mode on your ZENEC Tuner is lower than expected, it could be due to limitations of the local broadcasting system, which varies by area. Perform a “Scan” to rescan all available channels. Also, note that some radio channels may not be available in your specific area; only locally broadcasted channels can be received.
Read and follow all safety instructions and warnings for safe operation and to prevent damage.
Details the pin configuration for the power supply connector.
Explains the function of each pin in the power supply connector.
Provides notes on ideal locations and prohibited areas for antenna installation.
Describes the screen elements and controls during DAB radio playback.
Details the procedure for saving preferred radio stations for quick access.
Identifies and labels all buttons on the remote control.
Provides solutions for problems like the device not working or muted audio.
Offers solutions for problems related to DAB channel availability and signal quality.
To Next Page
General