Page 50
Menu Function Value Default Brief Description of Function and Comments
Item Range Value
088. EN. MUTE NOISE 0 / 1 1 If set to 1, the audio signal volume is limited to
a minimum value if no signal is being received from
the broadcaster.
089. POKE ENABLE 0 / 1 0 If set to 1, writing to non-volatile memory
through *M.P.I. is enabled.
090. NOT USED
091. NOT USED
092. NOT USED
093. NOT USED
094. NOT USED
095. NOT USED
096. NOT USED
097. NOT USED
098. NOT USED
099. NOT USED
100. NOT USED
101. NOT USED
102. NOT USED
103. NOT USED
104. NOT USED
105. NOT USED
106. ASP. RATIO LOCK 0 / 1 0 Set to 1, to retain current aspect ratio at turn Off.
At turn On, last set aspect ratio will be used. Set to 0 to
reset picture aspect ratio to default at TV turn On.
Installer Menu
Installer Menu Items 88 through 106
Detailed Descriptions of Installer
Menu Items
00. INSTALLER SEQUENCE
Gives access to Installer Menu depending on the
access code selected.
0 = 9876 1 = 4321
2 = 1478 3 = 3698
01. POWER MANAGE (Power Management)
Determines hours of no activity before automatic
shutoff. The POWER MANAGE function is for saving
energy. If set to 0, Power Manage is Off. Settings
range from 0 - 7, with 1 - 7 representing the hours
that the TV will remain On, unless there has been
activity from either the control panel or remote
control.
*M.P.I. Multiple Protocol Input: Zenith protocol for
remote control of TV through RJ11 (M.P.I.) jack on
TV connections panel.
02. AC ON (AC Power Switchable)
Allows the TV to turn On just by applying AC
power. Pressing the POWER button is not neces-
sary. This is desirable when the TV is plugged into
a cable box or a power outlet controlled by a wall
switch. Use ADJ to select 0 or 1, where 0 is the
default is Off, and 1 is On.
Note: If set to 1 (On), the TV does not respond to
On/Off commands from either the remote or the
control panel, and the SLEEP TIMER is also not
functional.
03. BAND/AFC (Band/Automatic Frequency
Control)
There are 8 possible settings for this option:
0 = Broadcast Fixed 4 = Broadcast AFC
1 = CATV AFC 5 = CATV Fixed
2 = HRC AFC 6 = HRC Fixed
3 = IRC AFC 7 = IRC Fixed
Channels are accessed faster when fixed modes are
used. The AFC (search modes) should only be used
To Next Page
Loading...
