Page 71
Troubleshooting
Some Quick and Easy Tips for Resolving Problems
Symptoms Possible Cause(s) Possible Solution(s) Page(s)
Source Selection / Source Image Problems
(For Sources to appear in Source menu, they must be enabled in Installer menu.)
Can’t select S-Video • Not enabled in Installer menu. Set installer menu item 037 Y/C Enable to 1. 48/52
on Source menu. • Not selectable on menu. Key in 132 and press Enter to show S-Video on screen.
Camport (Front Audio • Not option on Source menu. Set Installer item 40-I Camport, to 0 to enable 48/53
/ Video not available and appear as an option in Source menu.
on Source menu. • Not enabled in Installer menu. Set Installer item 34-I Camport En to 1 to enable 48/52
and appear as an option in Source menu.
• Equipment not connected. Connect Audio/Video equipment to front Audio/Video. 24
No Camport image. • Equipment not turned On. Turn equipment On connected to front Video input. 23
(Front Video)
Compport (Front SVGA • Not option on Source menu. Set Installer item 41-I Compport, to 0 to enable 48/53
Computer In) not available and appear as an option in Source menu.
in Source menu.
• Equipment not connected. Connect computer to TV front panel Computer In port. 24
No Compport image. • Equipment not turned On. Turn equipment On connected to front Computer In. 23
(Front PC SVGA)
• PC video output not set Set PC computer video output to CRT.
to output to CRT. (Usually Function key + F control key, see PC manual.)
S- Video Source not • Not shown on Source Set Installer item 37-I Rear Y-C En., to 0 48/53
selectable. menu. to enable and appear in Source menu.
• Not connected. Connect Y-C S-Video equipment to S-Video In. 20
No S-Video image. • Equipment not turned On. Turn On equipment connected to S-Video In.
No S-Video audio. • S-Video audio not Connect audio for S-Video to Audio In R - L. 20
connected. (Use Audio In Left jack to connect only one audio wire.)
No Antenna • Not Connected. Connect over-the-air antenna or cable service 15
Cable image. wire to Antenna/Cable digital antenna jacks.
• Cable provider problem. Contact cable service provider.
• Digital Cable service signal. TV cannot process digital cable signals.
Aux Video (Rear A/V) • Deleted in Add/Del/Blnk. Go to Setup menu, select Add/Del/Blnk option. 31
not available in menu. Channel down to lowest channel, next channel is Aux.
channel scan. Select “Added" in Add/Del/Blnk option in Setup menu.
Ch-3, Ch-4 not available • Deleted in Add/Del/Blnk. Go to Setup menu, select Add/Del/Blnk option. 31
in channel scan. menu. Channel down to Ch-3 or Ch-4.
Select “Added" in Add/Del/Blnk option in Setup menu.
No rear Audio • Equipment not turned On. Turn On equipment connected to rear Audio/Video.
Video image.
• Equipment not connected. Connect equipment to rear Audio/Video. 15
To Next Page
Loading...
