Zero DSR 2018

Troubleshooting
7.3
NUMBER OF RED FLASHES CAUSE SOLUTION
1
Safety Override is Active (when blinking
fast constantly)
1
BMS Isolation Fault (when blinking fast
intermittently)
1
Charger Not Charging (when
accompanied by fast constant blink of the
Charge LED or all blinking dash
segments)
1
Motor Stop Switch Disabled or Kickstand
Switch Disabled
Motor stop switch is in the OFF position. Press the
motor stop switch ON button. Kickstand is down.
Raise kickstand.
2 Self-Test Failed Contact Zero or your dealer.
3 High Throttle Disable
Throttle is ON or throttle/connection is bad. Verify
throttle action and/or check connection.
4 Precharge Fail
Could not pre-charge motor controller. Contact Zero
or your dealer.
5 Low Power Pack Disable Charge Power Pack Before Riding.
6 Contactor Error Contact Zero or your dealer.
7 Charger Problem Contact Zero or your dealer.
Zero Owner's Manual (S and DS).book Page 3 Wednesday, February 28, 2018 11:21 AM