General Maintenance
6.24
Turn Signal Light Bulb Replacement
1. Remove the turn signal lens screw (A) and remove the
lens.
2. Push in on the bulb, turn the bulb counterclockwise,
and then pull the bulb out.
3. Insert the new bulb into the socket, push in and turn
clockwise until it stops.
4. Install the lens and screw; tighten the screw. Do not
over-tighten the screw.
Brake/Tail LED Replacement
The brake/tail LED (A) is not serviceable. Please contact
your Zero Motorcycle dealer for replacement.
Zero Owner's Manual (S and DS).book Page 24 Wednesday, February 28, 2018 11:21 AM
To Next Page
Loading...
