Controls and Components
3.19
F. Motor Stop Switch
When the top of the switch (A) is pressed, it cuts off
power to the run signal. The motor controller remains
in this state until the bottom portion of the switch (B) is
pressed. The switch does not turn off all electrical
circuits, just the operation of the motor.
G. Performance Level Mode Button
See “
Performance Level Mode Button”, on page 3.21.
H. Hazard Warning Flasher Switch
When the top of the switch is pressed, the turn signals
flash to warn other drivers of situations, which include
needing to stop or park under emergency conditions.
When the bottom of the switch is pressed, the hazard
warning circuit will turn off.
I. Turn Signal Switch
When the turn signal switch is pushed in
the left or right position, the corresponding
front and rear turn signals flash. When the
turn signal switch is ON, the corresponding turn signal
indicator on the lower dash illuminates.
Always signal your turns and other maneuvers as
required by law. Unlike an automobile, the turn signals
must always be canceled manually on the motorcycle.
Push in on the switch and it will return to the OFF
position (center).
Zero Owner's Manual (S and DS).book Page 19 Wednesday, February 28, 2018 11:21 AM
To Next Page
Loading...
Need help?
General
