Troubleshooting
7.6
CODE ERROR DESCRIPTION
0 No Error
1 High Throttle
2 Motor Temperature Warning Stage 1
3 Motor Temperature Warning Stage 2
4 Controller Temperature Warning Stage 1
5 Controller Temperature Warning Stage 2
6 BMS Throttle Enable Wire Error
7 Low Battery Voltage
8 High Battery Temperature Status
9 Low Battery Temperature Status
10 Battery Temperature Warning Stage 1
11 Battery Temperature Warning Stage 2
12 Reserve Partition Warning
13 Reserve Switch Warning
14 Safety Override Active
15 Charger Attached But Not Charging
16 CIB Contactor Compromised
17 Charger Error
18 Battery Temperature Sensor Fault
19 High Charge Current
20 BMS Low Isolation
21 Board Vpack Error
22 Board Temperature Error
23 Post Error
24 Startup Error
25 Contactor Open Warning
26 Contactor Welded Error
27 Precharge Error
28 BMS Isolation Fault
29 BMS Isolation Danger
30 BMS CAN Error
31 SEVCON CAN Error
32 Module Variance Too High
33 SEVCON Error Turn Off
34 Charge Error Turn Off
35 Loopback Error
36 Board 5V Error
37 Board 3 3V Error
38 Idle Turn Off
39 Throttle Out Of Range Disable
40 BMS Throttle En Wire Disable
41 Low Battery Voltage Disable
42 High Battery Temperature Status Disable
43 Low Battery Temperature Status Disable
44 Kill Switch Disable
45 Kickstand Switch Disable
CODE ERROR DESCRIPTION
Zero Owner's Manual (S and DS).book Page 6 Wednesday, February 28, 2018 11:21 AM
To Next Page
Loading...
Need help?
General
