Power Pack and Charging
5.3
When connected to the charger, the power pack will
receive a full charge. Once fully charged, the charger
will cycle between 90% and 100% state of charge.
When the state of charge gets close to 90%, the
charger will recharge to 100% and repeat. When fully
charged, a green light illuminates on the charger.
Should the charger not read that the power pack is full,
it continues to attempt to fully charge the power pack. In
this event the green light may not illuminate; however,
the power pack may be fully charged. To ensure that
the power pack is charged, check the charge indicator
on the dash display prior to riding.
If the power pack terminates the charge before the
charger reaches the state previously mentioned, then
the charger continues to cycle and tops off the power
pack until the power pack is removed from the charger,
or the charger reaches the complete state previously
noted.
Zero Owner's Manual (S and DS).book Page 3 Wednesday, February 28, 2018 11:21 AM
To Next Page
Loading...
Need help?
General
