General Maintenance
6.11
Rear Brake Fluid Reservoir
The reservoir is located inboard on the frame behind the
heel guard.
Note: The motorcycle should be in an upright position prior
to checking fluid level.
Inspect the level of the rear brake fluid through the
reservoir housing. If the fluid level is visibly below the low
minimum LOWER indicator (C), brake fluid must be added
until level reaches the upper UPPER indicator (B). Do not
overfill.
Clean any dirt or debris from the cap and reservoir opening
(A) before opening the reservoir.
Unscrew the cap and add new DOT 4 brake fluid. Inspect
the cap seal ensuring that it is free of any wear or damage
then reinstall the cap.
Zero Owner's Manual (S and DS).book Page 11 Wednesday, February 28, 2018 11:21 AM
To Next Page
Loading...
