65
OPERATION
F 82 F 83 F 84
BEFORE STARTING
Before starting the engine be
sure that
1.
the tractor is braked by
parking brake.
2. main shifting lever and rever-
sor lever is in neutral position.
If the shifting lever is in a dif-
ferent then neutral position trac-
tor can not be started - safety in-
terlock switch is not actuated.
STARTING THE ENGINE EQUIPPED
WITH GLOW PLUGS
Tractors Z 8621 - 10641 are equipped
with glow plugs as a standard.
1. Insert the key into the key switch
("0" position).
2. Depress the clutch pedal.
3. Move the main shifting lever and
reversor lever into neutral.
4. Set the increased throttle control
(approx. 3/4 maximal delivery).
5. Turn the key into "I" position. Yellow
indication lamp on the dashboard is
“ON“. The indication lamp indicates
correct function of glowing.
In case the indication lamp is
flashing the glowing system
failed. In spite of this, the engine
can be started but without function of
glow plugs. Let repair the indicated
failure in a specialized workshop.
6. Wait until the indication lamp is off.
7. Turn the key into "II" position (start).
8. Release the key immediately after
starting the engine. Do not start lon-
ger then 15 sec.
9. After starting the engine, reduce
gradually the fuel delivery. Avoid
running the engine at high speed.
Note: According to the personal
experiences of driver it is possible to
start sooner then glow indicating lamp is
off. Proceed similarly when starting the
hot engine.
PDF byl vytvoren zkusebnı verzı FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
