80
OPERATION
F 118 F 119 A 120
STOPPING THE TRACTOR - PARKING
BRAKE
At normal conditions stop the tractor
gently and slowly.
Shortly before stopping:
1.
Depress the clutch pedal
2. Move the main shifting lever into
neutral
3. At each tractor stopping set the
parking brake and so protect the
tractor against accidental movement.
Indicator lamp located on the dash
indicates parking brake setting.
STOPPING THE ENGINE
Engine must be cooled after work with
fully loaded tractor.
1. First reduce the engine speed to 800
- 1000 RPM before stopping the
engine and let it run without load
approximately for 5 minutes.
2. Move the throttle control lever into
STOP position.
3. Pull up the stopping device and keep
it in pulled position up to stopping the
engine.
At tractors Z 11641 with electro-
nic governor the engine is stop-
ped by turning the key in key
switch into “0“ position.
LEAVING THE TRACTOR
Key can be turned from "I" position into
"0" position at stopped tractor only
indicator lamp of charging must be ON.
Tractor must be properly assured
against accidental moving when on the
hill: braked, with engine “off “, reverse
gear shifted and with low gear shifted by
main shifting lever Wheels must be
locked by blocks.
Remove the key from the key
switch and lock the cab at cab
tractors before leaving.
PDF byl vytvoren zkusebnı verzı FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
