05
Installation instructions & user manual
804545UK V2.03 Aug 2018 - Zip Hydroboil
Technical support
Tel: 0345 6 005 005 Email: service@zipindustries.co.uk www.zipwater.co.uk
Before installation
Technical specification, page 5 for power ratings.
Note Check cable and plumbing against inlet /outlet positions before proceeding.
•
A wholesome water supply connection with isolating valve within reach of the Hydroboil and positioned so
that the stop cock will not be obstructed when the Hydroboil is installed.
• Vent / outlet drainage to a draining board, drip tray or sink bowl area
.
•
A wholesome cold water supply with a minimum working pressure of:
(see Technical specification, below min. / max. water supply pressure).
•
A 0.35 MPa (3.5 bar) pressure limiting valve supplied must be fitted if the incoming mains water pressure is
likely to exceed 0.5 MPa (5.0 bar).
•
The Hydroboil must be placed with its base in a horizontal position.
IMPORTANT!
Do not proceed with the installation if these requirements are not met.
Technical specification
Product
code
Tank
size
(litres)
Heat up
time
(Inlet
15°C)
Heat up
time
(Inlet
10°C)
Rated voltage and
power
Dimensions
(mm)
W x D x H
Filled
weight(Kg)
301552 1.5 10mins 11mins 220-240V, 50Hz, 1400W 289 x 180 x 335 10.0
303552 3.0 16mins 17mins 220-240V, 50Hz, 1400W 289 x 180 x 431 12.5
305552 5.0 16mins 17mins 220-240V, 50Hz, 2200W 318 x 198 x 465 16.5
307552 7.5 23mins 23mins 220-240V, 50Hz, 2200W 318 x 198 x 578 20.5
310552 10.0 38mins 40mins 220-240V, 50Hz, 2800W 390 x 244 x 600 29.5
315552 15.0 40mins 43mins 220-240V~, 50Hz, 2800W 390 x 299 x 600 34.5
325552 25.0 47mins 50mins 220-240V~, 50Hz, 2800W 390 x 299 x 780 47.0
340552 40.0 60mins 64mins 380-415V, 2N~, 50Hz, 5600W 515 x 284 x 840 71.0
Min / Max water supply pressure
Hydroboil.........................................0.07 MPa (0.7 bar) - 0.5 MPa (5.0 bar)
WARNING ! If the incoming mains water pressure is likely to exceed 0.5 MPa (5.0 bar), a 0.35 MPa
(3.5 bar) pressure limiting valve must be installed in the cold water supply line.
Note Optional Water Block is recommended to be fitted in the water supply line to minimise the potential damage
in the event of leakage, call Zip on 0345 6 005 005.
To Next Page
Loading...
