Installation instructions & user manual
804545UK V2.03 Aug 2018 - Zip Hydroboil
Technical support
Tel: 0345 6 005 005 Email: service@zipindustries.co.uk www.zipwater.co.uk
Installation instructions
Use the spanner provided to tighten the lock nut.
Fit the boiling water safety label supplied in a prominent visible
position for users of the Hydroboil
Step 4 - Assembly
• Refit the outer case and secure the 2 sets of screws top and bottom (see page 6 to 7).
• Before installing the tap, ensure enough P.T.F.E thread tape is applied to the thread.
• With the cover on, fit the red escutcheon over the outlet tube, secure with the locknut.
• Screw the tap assembly clockwise onto the outlet tube until it touches the escutcheon locknut. Continue to turn the
tap until the handle is fully vertical. Tighten the locknut against the tap with spanner provided.
To Next Page
Loading...
