Hydro Tap Installation and Operating Instructions - 89026UK - June 2009 Page 19 of 24
Setting the Energy Saver Timer (Model: 437677UK )
Normal Operation (not available on HT boiling only series)
Set Time
To change time, press either Menu
>
or Menu
>
button until Set Time is on the display screen.
Press
>
Adjust button to increase time or
>
Adjust button to decrease time. Time increases
or decrease in increments of one minute. Hold the Adjust buttons down for rapid increases or
decreases. The time will be displayed in 24Hr mode.
Set Language (option for EU models only)
EU models will have the default language set for German. To select English as the default press
the
>
Adjust button. To select German as the default Press
>
Adjust button.
Set Day
Press either Menu
>
or Menu
>
button until Set Day is displayed.
Press
>
Adjust or
>
Adjust to select day.
Filter Life ( Factory set at 6000 Ltrs )
Press either Menu
>
or Menu
>
button until Filter Life is displayed.
Press
>
Adjust button to increase Filter Life or
>
Adjust button to decrease Filter Life.
Filter Life increases in 1000 Ltr increments to a maximum of 10000 Ltrs.
Reset Litres Filtered
This function is to reset the Filter Change display after a filter has reached the end of its life (refer
to “Replace Filter Instructions” section of this document).
Press either Menu
>
or Menu
>
button until “Litres Filtered” is displayed. Press
>
Adjust once
and “Reset Counter” will be displayed, press
>
Adjust button once and “Are You Sure” will be
displayed.
Press
>
Adjust once and “Litres Filtered” will be reset to 0.
Activating Sleep Mode
This mode allows the HydroTap to go into Energy Saving mode. In this mode the unit will
go to “sleep” after a predetermined period of inactivity. Press either Menu
>
or Menu
>
button until “Sleep Mode” is displayed. Press
>
Adjust once to select 2 Hours or twice to
select 4 Hours. When the period of inactivity passes, the display will show “Sleep Mode”.
During the “Sleep Mode” the Red LED on top of the tap lever will flash slowly.
To de-activate the sleep mode, momentarily operate the Hot lever and then allow sufficient time
for the water to reach the set temperature. When complete, the Red light will stop flashing.
Activating On / Off Mode
Press the Menu
>
or Menu
>
button until “Monday On” is displayed. To set the time for the unit
to turn on press
>
Adjust button until required time is reached.
To set the time for the unit to turn Off press Menu
>
button once and “Monday Off” will be
displayed. Now press
>
Adjust until required time is reached.
If each individual day is to have an “On / Off” time, these steps need to be repeated for each day
and for each On / Off time.
Menu Plus Button
Menu Minus Button
Plus Adjust Button
Minus Adjust Button
Note:
Menu buttons
change the
screen options
Adjust buttons
select the
screen options
To Next Page
Loading...
Need help?
General
