40
Quick Start Installation Guide
807119 v1.08 05.23 G5 BCS Quick Start Guide
TANK FLUSH 12:12 PM
Pause:
Sparkling Tank
Cycle 1/1
Flushing sparkling
reticulation
Auto
Dispense
Hot Tank
Cycle 0/2
100.0
O
C
Dispense hot
water to empty
tank.
SAFETY ON
SECTION 14: Commissioning
EMPTY HOT TANK 12:12 PM
Press and hold to
empty tank
100.0
O
C
Dispense boiling
water using the
tap safety
feature
WARNING ! Boiling water
will be dispensed ! Check
sink area remains safe
OR
• Note For all boiling models, if after
filling the hot tank during the tank flush
process, the hot water temperature is
still above 50
0
C the tank will need to be
emptied again.
• Monitor the on screen information.
• The hot tank will cycle twice.
• The sparkling tank will cycle once
on both the chilled and sparkling
reticulation.
INSTALL CO2 BOTTLE 12:12 PM
Connect and turn on CO2 bottle.
Set pressure to 300kpa / 43.5psi if not preset.
• Read the on screen information.
• Ensure that the CO cylinder is connected
and if supplied with an adjustable
regulator, set to 3.0 bar (300kPa).
• Touch the green arrow to run.
• CO life settings should be adjusted for the
size of the CO bottle connected. (see the
User guide or Online Installation and User
guide.
12:12 PMPURGE WATER WITH CO2
INFO
This process removes water from the sparkling
chamber when a new CO2 bottle is installed.
This is an automatic process that will take 30 seconds.
12:12 PURGE WATER WITH CO2
Running
Water is now being purged from the sparkling chamber.
| |
Skip
• Use the skip arrow to end the CO purge
process prematurely if all water has
been purged and only gas can be heard
coming from the tap.
To Next Page
Loading...
