3 Preparation
2
To install the Mars-B1000 Series you must have:
A Screwdriver: To remove or install the screw on the device.
A Pencil: To mark the device size and the screw hole.
A Electric Drill: To drill holes according to the marked screw holes.
A Wrench: To secure the M12 expansion screw on the device.
4 Installation
1. Place the turnstile to the installation site.
1010.00
1355.00
A Tapeline: To measure the dimensions that need to be measured during the installation of the device.
To Next Page
Loading...
Need help?
General
