What to do if ZKTeco TS1022 Pro do not grant access after authentication?
If a ZKTeco turnstile doesn't grant access after successful authentication, here's what to check: 1. Verify the user has the necessary permissions. 2. Use a multimeter to check the NO and COM ports of the access control system for a relay signal output. 3. Short-circuit the ports "K1, GND" and "K2, GND"; if the turnstile opens, inspect the access controller.
What to do if ZKTeco Turnstiles allows continuous one-way passing?
If ZKTeco turnstiles allow continuous passing on one side, you can try the following: 1. Check the turnstile-opening solenoid. 2. Ensure the access controller’s “Lock driving duration” is set to 1s. 3. Check the operation of the turnstile-opening solenoid and inspect for any obstructions.
How to troubleshoot a ZKTeco TS1022 Pro Turnstiles indicator that is not lit?
If the indicator on your ZKTeco turnstile isn't lit when powered on, the issue might stem from the power supply or circuit. Check the connection and power cables for any damage, and ensure all wiring is securely connected.
Why arms of ZKTeco TS1022 Pro cannot be lifted manually after power on?
If the arms of your ZKTeco tripod turnstile cannot be lifted manually after powering on, it could be due to related component issues or a problem with the drop-arm solenoid. Check if the drop-arm solenoid is operating correctly and inspect its working status.
What to do if ZKTeco Camera Accessories tripod turnstile does not grant access after successful authentication?
If the ZKTeco Camera Accessories tripod turnstile doesn't grant access after authentication, first, ensure the user has the necessary permissions. Next, verify the access control system's NO and COM ports have a relay signal output using a multimeter. Finally, short-circuit the 'K1, GND' and 'K2, GND' ports; if the turnstile opens, the controller is likely faulty.
Why is ZKTeco Camera Accessories turnstile allowing continuous passing one-way?
If the ZKTeco Camera Accessories turnstile allows continuous one-way passage, check the turnstile-opening solenoid. Also, verify that the access controller 'Lock driving duration' is set to 1s. Ensure the turnstile-opening solenoid is functioning correctly and that nothing obstructs it.
How to troubleshoot ZKTeco Camera Accessories when the indicator is not lit after powering on?
If the indicator light is off when your ZKTeco Camera Accessories equipment is powered on, check the connection and power cables for damage. Also, ensure that all wiring is securely connected.
What to do if ZKTeco Camera Accessories tripod turnstile arms cannot be lifted manually after power on?
If the arms of your ZKTeco Camera Accessories tripod turnstile cannot be lifted manually after powering on, examine the drop-arm solenoid for proper operation. Also, check the working status of the solenoid.
General| Brand | ZKTeco |
|---|---|
| Model | TS1022 Pro |
| Category | Turnstiles |
| Language | English |
To Next Page