What to do if ZKTeco Turnstiles allow continuous one-way passing?
If the ZKTeco Turnstiles allow continuous passing on one side, examine the turnstile-opening solenoid. Ensure the access controller's "Lock driving duration" is set to 1 second. Also, verify the solenoid's operation and check for any obstructions.
Why ZKTeco TS1000D Turnstiles do not grant access after successful authentication?
If a ZKTeco tripod turnstile fails to grant access after authentication, it could be due to insufficient user permissions or a circuit issue. Verify the user's permissions. Use a multimeter to check for a relay signal output from the NO and COM ports of the access control system. Short-circuit the "K1, GND" and "K2, GND" ports; if the turnstile opens, the controller is likely faulty. In this case, check the cable connection of the controller.
How to fix ZKTeco Turnstiles arms that cannot be lifted manually?
If the arms of your ZKTeco tripod turnstile cannot be lifted manually after powering on, the issue might stem from related components or the drop-arm solenoid. Check if the drop-arm solenoid is functioning correctly and examine its working status.
What to do if the indicator light is off on ZKTeco TS1000D Turnstiles?
If the indicator light on your ZKTeco Turnstiles is not lit when the equipment is powered on, it could be due to the power supply or a circuit problem. Check the connection cable and power cable for any damage, and ensure the wiring is secure.
General| Brand | ZKTeco |
|---|---|
| Model | TS1000D |
| Category | Turnstiles |
| Language | English |
To Next Page