TS2000 Pro Series Tripod Turnstile User Manual
P a g e |
9
Copyright©2020 ZKTECO CO., LTD. All rights reserved.
Figure 3-2
Cabling
There are inlets in the bottom plate for cabling, as shown in Figure 3-3, the unit is millimeter. Power supply
and communication wire should go through the inlet. Cable protection covers are suggested to use if it is
surface mounted.
Warning:
The tripod turnstile must be connected to the ground (earth), there is wiring interface near the
power switch.
Figure 3-3
Installation
1. Drill holes.
Drill holes based on the locations of holes as shown in Figure 3-3.
To Next Page
Loading...
Need help?
General
