ZKTeco X7 User Manual

1
Instructions
Step 1: Power on after the device is completely installed on the wall.
Step 2: Authenticate administrator password and change it immediately. Adjust access
control parameters, which include changing passwords for door opening, and setting
unlocking duration, authentication mode, concealed mode, door sensor mode and
alarm etc.
Step 3: You may register and authenticate user accounts, cards or passwords.
Operation Instructions
1. User Management
1.1 Administrator Operation
To ensure data security of the device, users can operate the device only after the
administrator password is authenticated.
 Administrator Authentication
1. Press [*]
(The indicator is off and makes
a long beep.)
2. Press[#].
(Enter step of password
authentication.)
3. Enter the administrator
password.
(The default password is 1234.)
5. Exit.
(Press [*] or do not operate
the device within 20 seconds,
The indicator turns red and
makes a long beep, then
automatically exit.)
4. Authentication succeeds.
(The indicator turns green.)
Note: The default administrator password is 1234. You are advised to change the
initial password at the beginning.
 Change Administrator Password
1. The administrator
password is authenticated.
2. Press [8].
3. Enter a new administrator
password.
Succeed
5. Password is successfully
changed. (The indicator turns
green and makes a long beep.)
4. Enter the new administrator
password again for
authentication.
6. Exit.
(The indicator turns red
and makes a long beep.)
Fail
(The indicator turns red
and makes three beeps.)
Note: Four-digit passwords are automatically verified. If passwords less than four
digits, press [#] to confirm.

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English