ZKTeco X7 User Manual

8
 Configuring Tamper Alarm
If this function is enabled, alarms will be raised when the device is dismantled from the
wall.
1. The administrator password
is authenticated.
2. Press [7].
(The indicator turns green
and makes a long beep.)
3. Configure Tamper Alarm
Switch. (0: enable; 1: disable).
5. Exit.
(The indicator turns red and
makes a long beep.)
4. Configuration succeeds.
(The indicator turns green and
makes a long beep.)
 Configuring Door Sensor Delay
When the door is not closed well after a time period, the Door Sensor Delay will raise an
alarm to alert users. Its configured value is the time period denoting how long after the
door is opened will the alarm ring.
1. The administrator password
is authenticated.
2. Press [0].
(The indicator turns green
and makes a long beep.)
３．Press [4].
(The indicator turns green and
makes a long beep.)
5. Configuration succeeds.
(The indicator turns green
and makes a long beep.)
４.Configure the Door Sensor
Delay. (range: 1s to 254s).
6.Exit.
(The indicator turns red and
makes a long beep.)
Note:
1. Three-digit values will be automatically verified. For values with less than three digits,
press [#] to confirm. Values greater than 254 are considered invalid.
2. When an alarm is triggered, the device interior alarm will be triggered first, 30 seconds
later, the device exterior alarm will be triggered.

ZKTeco X7 Specifications

General

Brand	ZKTeco
Model	X7
Category	Gateway
Language	English