ZKTeco X8-BT User Manual

9
 Configuring Tamper Alarm
Press【7】
Press【*】to exit
Verify administrator
fingerprint
Press【*】+【#】
Configure tamper
alarm switch【#】
(0:enable，1:disable)
If this function is enabled, alarms will be raised when the device is dismantled from the wall.
 Configuring Door Sensor Delay (default value: 10s)
When the door is not closed well after the set time period, the Door Sensor Alarm will generate
an alarm signal to alert the users.
Press【0】+【4】
Press【*】to exit
Verify administrator
fingerprint
Press【*】+【#】
Configure the door
sensor delay【#】
(range：1s~254s)
Note:
① Values greater than 254 are considered invalid. The indicator turns red and makes four short
beeps.
② When an alarm is triggered, the device interior alarm will be triggered first. After 30 seconds,
the device exterior alarm will be triggered.

ZKTeco X8-BT Specifications

General

Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	20 - 80 %
DC input voltage	12 V

Weight and Dimensions

Width	90 mm
Height	38.9 mm