ZKTeco X8-BT User Manual

6
Verify administrator
fingerprint.
Press【3】
Enter four digits
password twice, end
with【#】each time
Enter the group ID
（Group IDs：1~8）
Press【*】+【#】
Press【*】to exit.
Note: When a password is changed to 0000, the password is disabled. When a password is
successfully changed, you can immediately change the next password by entering another
group ID.
Fingerprint/ Card /Password Authentication
When the device is powered ON, it enters user authentication state (flash blue light).
1.The device is in user
authentication state.
2.Enter password【#】
/fingerprint/swipe user card
3.User
authentication
succeeds.
Note: The door opens only if the entered password matches with one of the 8 passwords. The
initial eight passwords for opening the door are set to 0.
 Deleting One User
Press【2】
(The indicator turns
green and makes a
long beep)
Press【*】to exit
Enter user ID【#】
/fingerprint/swipe user card
(The indicator turns green
and makes a long beep)
Verify administrator
fingerprint
(The indicator turns
green and makes a
long beep)
Press【*】+【#】
Note: After successful deletion, the device will automatically enter the process of deleting next
user. Press [*] to exit.
 Deleting All Users
Press【9】+【#】
(The indicator turns
green and makes a
long beep)
Press【*】to exit
(The indicator turns green
and makes a long beep)
Verify administrator
fingerprint
(The indicator turns
green and makes a
long beep)
Press【*】+【#】
11. User Deletion
10. User Authentication

ZKTeco X8-BT Specifications

General

Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	20 - 80 %
DC input voltage	12 V

Weight and Dimensions

Width	90 mm
Height	38.9 mm