13
8010001002
X Series User’s Manual Chapter 2 Installation & Operation
Consumables installation
The Direct Thermal print method or Thermal Transfer print method can be used in the X Series printer.
The Ribbon and Media should be load into the printer while the Thermal Transfer print method is
configured.
Only Media should be load while the printer is configured to the Direct Thermal print method.
You must use the correct media for the type of printing you require.
The route of loading the Ribbon and media as showed in Figure 5.
Please see “Loading the Ribbon” and “Loading the Media” for a complete description of the operating
procedures.
Thermal Transfer Media Loading Instructions
耗材安装示意图
Ribbon Route
Label Route(Alternative 1)
Label Route(Alternative 2)
碳带通道
标签通道1
标签通道2
Figure 5
To Next Page
Loading...