Page 3
2.1 Introduction ...................................................... 6
2.2 The Controller Panel ........................................ 6
2.3 The Controller Components ............................. 6
2.4 Installation of the Backplate onto an
Electrical Box ................................................... 6
2.5 Installation of the Backplate on a Flat Wall ...... 7
2.6 Connection to the Jandy ePump
Variable Speed Pump ....................................... 7
2.7 Jandy ePump Variable Speed Pump
Switch Settings ................................................. 7
2.8 Connection to Remote Contacts ...................... 8
2.9 Remote Operation ............................................ 8
2.10 Remote Closure 4 Behavior ............................. 8
2.10.1 Remote Closure 4 Application -
Booster Pump Support ..................................... 9
3.1 The ePump™ Controller .................................. 9
3.2 The ePump™ Controller Interface ................... 9
3.3 Basic Functions .............................................. 10
4.1 OFF Mode ...................................................... 10
4.2 RUN Mode ..................................................... 10
4.3 Manual Start and Stop ................................... 10
4.4 Pump Speed Setting ...................................... 11
4.5 Timeclock Setup and Operation ..................... 11
4.6 Remote Operation .......................................... 12
4.7 Pump Freeze Protect ..................................... 13
4.8 Keypad Lock .................................................. 13
5.1 Entering Service Setup .................................. 14
5.2 Minimum and Maximum Pump Speeds ......... 14
5.3 Load Defaults ................................................. 14
5.4 Last Fault ....................................................... 15
5.5 Priming Speed and Duration .......................... 15
5.6 eStar Speed ................................................... 16
5.7 Pump Freeze Protect Operation .................... 16
6.1 Setting Time-of-Day ....................................... 17
6.2 Labeling Presets ............................................ 17
6.3 General Labels ............................................... 17
6.4 Custom Labels ............................................... 17
6.5 Display Light Control ...................................... 18
6.6 Language Selection ....................................... 18
6.7 Run Duration (Presets 3 and 4 Only) ............. 18
To Next Page
Loading...