9 / 9
E
N
G
L
I
S
H
DEFLATING / FOLDING THE BOAT
1. Deflate the boat
2. Replace the valve protections.
3. Remove the floorboard.
4. Empty the boat of all water and sand by opening the self-bailers, dry it.
5. Fold in the 2 sides of the main buoyancy tube (A), fold the cones onto the transom, then
roll up the boat around the transom (C). Start again if you feel there is still some air left in the
tubes.
A B
buoyancy tube floor
tube deflated
C
Stow the boat in its bag as follows (D):
. Stow the boat folded on its bag open (back side of the bag visible).
. Position the floor sections and stringers flat on the boat , then the oars dismantled.
. Close the bag and fasten the two front straps.
. Tight the side ropes (make sure that all equipment stays inside).
. To finish, store the foot-pump in the front pocket.
D
To Next Page
Loading...
