/ 9
6
INFLATION
Activate all valves into inflation position.
Fit the hose to the foot-pump.
To inflate your boat properly, the bottom side of the foot-pump
must rest on a flat ground
. Pump evenly to inflate rapidly.
WARNING
DO NOT USE A COMPRESSOR OR A BOTTLE OF COMPRESSED AIR
INFLATE THE MAIN BUOYANCY TUBE AND THE KEEL
CAUTION
MAXIMUM PRESSURE IN THE MAIN BUOYANCY TUBE
AND IN THE KEEL : 240 MBARS (3.48 PSI)
Inflate the main buoyancy tube and the keel until it becomes difficult to operate.(correct pressure =
240 mb / 3.48 PSI), reefer to PRESSURE section making sure that each compartment is equal. When
correctly inflated, the compartments bulkheads are not visible.
NEVER COMPLETELY
INFLATE A
COMPARTMENT TO FULL
PRESSURE IF OTHER
COMPARTMENTS ARE
TOTALLY DEFLATED
A
100 %
0 % 0 %
1
50 %
50 %
50 %
2
100 %
100 %
100 %
Inflation is over: fit the valve caps tight (clockwise).
NOTICE :
A slight air-leak before screwing the valve caps is normal.
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
To Next Page
Loading...
