Zoeller AQUANOT 508 Fit User Manual

Product information presented
here reects conditions at time
of publication. Consult factory
regarding discrepancies or
inconsistencies.
MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347
SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961
TEL: (502) 778-2731 • 1 (800) 928-PUMP • FAX: (502) 774-3624
Visit our website:
zoellerpumps.com
FM3120
1120
Supersedes
1020
12 VOLT DC BATTERY BACKUP PUMP
INSTALLATION INSTRUCTIONS
PREINSTALLATION CHECKLIST
1. Inspect your pump. Occasionally, products are damaged during shipment. If the unit or any of the parts are damaged, contact your dealer
before using.
2. Carefullyreadtheliteratureprovidedtofamiliarizeyourselfwithspecicdetailsregardinginstallationanduse.Thesematerialsshouldbe
retained for future reference.
SEE BELOW FOR
LIST OF WARNINGS
1. Testing for ground. As a safety measure each electrical outlet
should be checked for ground using an Underwriters Laboratory
listed circuit analyzer, which will indicate if the power, neutral and
ground wires are correctly connected to your outlet. If they are not,
callaqualied,licensedelectrician.
2. For your protection, always disconnect the power supply from its
power source before handling the components of your DC backup
pump or the primary pump.
3. Installation and servicing of electrical circuits and hardware should
beperformedbyaqualied,licensedelectrician.
4. All electrical and safety codes must be followed including the
National Electrical Code and all applicable local codes.
5. It is the owner’s responsibility to check the battery and
battery connection at least once a month. Batteries
contain acid, and caution must be taken when handling.
6. Riskofelectricshock.Thesepumpshavenotbeeninvestigatedfor
use in swimming pools and marine areas.
7. Prop 65 Warning for California residents: Cancer and Reproductive
Harm- www.P65Warning.ca.gov.
1. Make sure there is a properly grounded 115 V receptacle available.
Donotuseprimarypumpcircuit.The location must be within 6'
(1.8m)ofthecontrolboxandbattery.Thepowersupplyforyour
DC control system plugs directly into the 115 V outlet. DONOTUSE
ANEXTENSIONCORD.
2. Make sure the 115 V electrical supply circuit is equipped with
fuses or circuit breakers of proper capacity.
3. DC emergency pumps are designed for handling clear water. Do
not use inseptictankstopumpefuentorinsewagepitstopump
sewage.
4. Repair and service of your DC backup system should be performed
by an authorized service station.
5. TheinstallationofDCautomaticbackuppumpsrequirestheuseof
avariableleveloatswitchforoperation.Itistheresponsibilityof
theinstallingpartytoensurethattheoatswitchwillnothangup
on the pump apparatus or pit peculiarities and is secured so the
pump will turn “on” and “off”. It is recommended that the pit be
18" (45.7 cm) in diameter or larger to accommodate both a primary
and a DC backup pump.
6. For indoor use only.
CAUTION
SEE BELOW FOR
LIST OF CAUTIONS
REFER TO WARRANTY ON PAGE 2.
CAUTION
  Turbulence caused by high-velocity incoming
water can cause sump pumps to airlock. If this condition exists,
theincomingwatermustbebafedtoavoidexcessiveturbulence.
Real Time Peace of Mind.™
US Patent No.
D740,329
© Copyright 2020 Zoeller
®
Co. All rights reserved.
155744-C

Zoeller AQUANOT 508 Fit Specifications

General

Brand	Zoeller
Model	AQUANOT 508 Fit
Category	Water Pump
Language	English

Summary

Preinstallation Checklist

Component Inspection and Preparation

Verify all parts are present, read literature, and handle components carefully.

Safety Warnings and Cautions

Electrical Safety and Grounding

Ensure proper grounding and use a qualified electrician for electrical connections.

Pump Operation and Handling Safety

Follow guidelines for pump operation, water handling, and battery safety.

Environmental and Specific Precautions

Observe California warnings and general operational cautions for safe use.

Limited Warranty

Product Description

Performance Specifications

Battery Selection

Exploded View - DC Pump

Installation Guide

Pump and Float Switch Installation

Install pump and float switch correctly, ensuring proper pipe connections and water levels.

Electrical Connections and Safety

Connect battery leads carefully, ensuring correct polarity and securing connections.

Initial Start-Up

System Check and Operation

Test system operation, check indicator lights, and verify pump cycles correctly.

Alarm and Float Switch Behavior

Understand alarm signals, float switch actions, and troubleshooting low water conditions.

Fit Controller Functions

Button Functions

Learn functions of Silence/Reset and Test buttons for system control and testing.

LED Indicator Status

Interpret LED lights for system status, battery charge, and pump operation.

Maintenance Procedures

System Testing and Battery Check

Perform monthly checks on system operation and battery electrolyte levels.

Troubleshooting Common Issues

DC Pump Not Running or Cycling

Diagnose issues with connections, battery, fuses, or pump obstructions.

Water Level and Pump Performance

Address problems like intermittent pumping, high water levels, or airlocks.

Alarm Activation and Reset

Troubleshoot alarm sounds, including battery recharge cycles and reset procedures.

Connecting to Z Control Cloud

Mobile App Connection

Connect the Aquanot Fit to the Z Control Cloud using the mobile app.

Direct Computer Connection

Connect directly to the Fit controller using your mobile device or computer.

Aquanot Battery

Carbon Monoxide Detectors

CO Detector Warnings and Actions

Understand potential hazards from CO gas and recommended actions.