Zoeller MEDIUM X5 - Starting and Finishing a Workday; Start

Operating instructions 43
4. Release trapped people using the release button . The release button is also active
after using the emergency stop.
5. Determine the cause and rectify any defects.
6. Unlock the emergency stop button by pulling or turning it.
ATTENTION
Do not use release button as a replacement for the press up button !
WARNING
In an emergency, use the emergency stop button! To restore vehicle functions after pressing the
emergency stop button, turn the button clockwise. Do not use a vehicle with an inoperative emergency
stop or release button.
6.3 STARTING AND FINISHING A WORKDAY
6.3.1 Start
Before starting work, proceed as follows:
o Make sure you have unlocked all the emergency stop buttons
o Start the vehicle engine.
o Turn on the key switch at the panel in the driver's cab.
o Set the lifters to the transport position (see chapter 9.2.3)
o For safety reasons it is recommended to activate the handbrake.
o Set the gearbox to neutral, if necessary, manually engage the auxiliary drive. Detailed
conditions for switching on the auxiliary drive are contained in the chassis manual.
ATTENTION
The manufacturer's guidelines for using the auxiliary drive must be followed.
o Select container loading mode on terminal (shown in Fig. 6.1).
Fig. 6.1 Container loading mode symbol