Operating instructions 44
o The position of the pushing wall must be checked before starting any collective round
(empty body). The pushing wall should be located approx. 0.5 m from the back of the
body. If necessary, move the pushing wall.
6.3.2 End of the workday
After finishing put RCV on parking position:
o Switch off the vehicle engine and remove the ignition key
o Secure the vehicle against involuntary rolling by applying the parking brake
o Press: slider on the top, scraper opened
o Set the pushing wall at the back of the body
o Close and secure tailgates
o Put the lifter in the parking position
The RCV is in parking position.
6.4 COMPACTION
Before driving the vehicle after loading, loaded waste must be pressed. If the waste
remains in the hopper while driving, they may fall out of it and cause damage to the traffic
participants behind the vehicle. The vehicle is adapted for crushing garbage according to the
working cycle described in the sections below. This cycle can be started as a one-time cycle,
semi-automatic or manual. Elements controlling the press are located on control panels on
both tailgates.
The loading process consists of 4 stages and in automatic mode takes about 12-14
seconds.
To Next Page
Loading...
