Troubleshooting
9 - 12
2.
Type "arp -s <print server's
IP> <print server's Node ID>" to specify a new ARP entry.
3. Refer to Chapter 7 for the detailed instructions to
complete the installation.
B. The print server's IP address is duplicated or is as
same as another computer's IP address on the
network.
If this is the case, please consult your network
administrator to obtain an unused IP address for your print
server.
C. The print server is on one segment and your
Windows NT server is on the other segment.
(This troubleshooting guide will also apply to a
multiple-segmented network while installing the print
server)
For example, assuming the print server is on Segment A,
NT server is on Segment B, and there is a gateway
computer between Segment A and Segment B. The
network might be a complete TCP/IP network, or a hybrid
of TCP/IP and IPX/SPX network.
If this is the case, you have to adopt the following steps,
depending on which platform the gateway computer is.
a. If the gateway computer is a NT/UNIX server:
To Next Page
Loading...
