The PSAdmin Utility for Windows-based
3 - 15
Multiple Print Queues Configuration
To configure the print server to service multiple print
queues, please follow the instructions listed below:
1. Log into your NetWare file server as a Supervisor
(Admin.) or equivalent.
2. Run the PSAdmin from your Windows.
3. Select the print server and to be configured.
4. Click the Wizard icon in the tool bar.
5. Type in a Print server and a Print Queue Name (For
more detailed information about Wizard, please refer
to the “Wizard” section in this chapter).
6. Run the NetWare’s PCONSOLE and create additional
print queues.
7. Select the Print server name you specify in Step 5.
8. Select the “Print server Configuration” option and
select the ”Queue Serviced by Printer” option (For
NetWare 4.x’s PCONSOLE, please select “Printers”
option and select “Printer 0” instead).
9. Select the “Printer 0” and press the [Insert] key to add
the print queues you create in Step 6 into the list (For
NetWare 4.x’s PCONSOLE, please select “Print
queues assigned” option instead).
10. Reset the print server by clicking the “Reset” icon from
the PSAdmin. Done.
Note: Please refer to NetWare’s Print server/Services
manuals for detailed PCONSOLE commands.
To Next Page
Loading...
