Troubleshooting
9 - 17
Question D
The Status LED light keeps blinking after POST.
Possible explanation and solution
The last upgrade process was not completed. The print
server must be upgraded again by using the PSAdmin.
Please see Chapter 3 for details.
Question E
The PSAdmin reports “Create Print server Error”, “Create
Printer Error”, or “Create Print Queue Error” while using
Auto Setup.
Possible Explanation
The print server name, the printer name, or the print queue
name you specified in the Auto Setup dialogue box
contains a space.
Solution
Check to see if there is a space in the print server name,
the printer name, or the queue name. Type in a new name
without a space between two characters or replace a
space by a dash (-) or an underscore (_).
To Next Page
