TCP/IP LPR Port Printing Installation
7 - 15
At the tftp prompt, type “put config.txt” to save the new
configuration file back to the Print Server.
For example:
tftp > put config.txt
10.
Ty
pe “lpsy
stem -tbsd <Print server‘s IP address>”
For example:
lpsystem -tbsd 192.72.214.103
Note: You can add the host name associated with the IP
address in the /etc/hosts file. If you have done this,
please use the host name instead of the IP address.
11.
Type “lpadmin –pprinter-1 -s <Print serv
er‘s IP
address>”
,where printer-1 represents the Print Server’s parallel
port. You can enter a printer name you like.
For example: lpadmin –pprinter-1 -s192.72.214.103
12. Type “accept printer-1”
For example: accept printer-1
13. Type “enable printer-1”
For example: enable printer-1
14. Submit print jobs by “ lpr ” command.
For example: lpr -Pprinter-1 /etc/hosts
To Next Page
Loading...
