WPS Settings
Wi-Fi Protected Setup (WPS) is the simplest way to build connection between
wireless network clients and ZSR4134WE. You don’t have to select encryption
mode and input a long encryption passphrase every time when you need to
setup a wireless client, you only have to press a button on wireless client and
this wireless router, and the WPS will do the rest for you.
WPS Mode: Supports two ways to configure WPS settings:
PBC) and PIN code.
PBC(Push-Button Configuration):
If you want to use PBC, you have to
push a specific button on the wireless client to start WPS mode, and
switch ZSR4134WE to WPS mode too. You can push WPS button of
ZSR4134WE, or click PBC button in the web configuration interface to
enable WPS
Note: Press WPS button of ZSR4134WE for one second and WPS indicator will
blinking for 2 minutes. During the blinking time, you can enable another Router to
implement the WPS/PBC negotiation between them. At present, the WPS only
support one client access. Two minutes later, the WPS indicator will be off.
PIN: if you want to use PIN code, you have to know the PIN code of
wireless client and switch it to WPS mode, then provide the PIN code of
the wireless client you wish to connect to ZSR4134WE.
To Next Page
Loading...
